|
The Takagi T-M1 water heater is state of the art and has many mounting and
venting options. These optional accessories may also be used with the AquaStar 240FX and
Takagi T-KD20 and T-KJR. Exterior mounting is for mild climates only (no freeze ups) and requires
an optional Vent Terminator.
Model TM-RE10
|
The TM-RE10 Temperature Remote Controller has two functions. It allows the output
temperature from the T-M1 to be adjusted within the range of 99°F to 182°F
and it also works as a diagnostic tool that will give a concise error code whenever
there is a problem with the unit. The temperature options are 99°F, 100°F,
102°F, 104°F, 106°F, 108°F, 109°F, 111°F, 113°F, 115°F,
117°F, 122°F, 131°F, 140°F, 158°F and 167°F or 182°F.
|
|
Model TK-TV01
|
The TK-TV01 wall vent terminator for installation of Takagi water heaters to be vented out a
side wall. This is a CSA tested Takagi component. Connect the Category III stainless
steel vent pipe from the top of the unit to the backside of this terminator to
exhaust flue gases through the wall without a thimble.
|
|
Model TK-TV06
|
The TK-TV06 Vent Cap is for outdoor installation of the T-M1 tankless water heater.
The cap is installed on the top of the unit, instead of connecting an exhaust vent pipe.
The cap will prevent any debris that might be in the environment from entering the unit
and causing damage or a fire hazard, as well as preventing rain or other weather
from entering the unit.
|
|
Model TM-RE20
|
The TM-RE20 is for multi system control of the T-M1. This can control a maximum of
twenty TM1 units, which means a BTU rating from 25,000 to 4,700,000 BTU. And it also works
as a diagnostic tool that will give a concise error code whenever there is a problem
with the unit. When the TM-RE20 is used, the TM-RE10 must be used in the installation
as well.
|
|
Model TK-BF01
|
A 4-inch back draft preventer should be used when outside temperatures
are below 32°F. The TK-BF01 prevents cold air from freezing the
heat exchanger on the T-M1.
Click here for a TK-BF01 venting example
|
|
Z-Flex Venting
|
Z Flex Stainless Steel Venting Accessories with silicone free connections. See
our full line of pipe, exterior terminators, elbows and more. Perfect for vertical
or horizontal installation. Stainless Steel Venting is required for all Takagi
Water Heaters (Exhaust Only).
Click here to see sizes and prices for ZFlex Venting Supplies
|
|
|
