Tankless Water Heaters / Electric / Gas/ Takagi T-KD20 / Gas Water Heater Venting

Takagi T-KD20 Tankless Water Heater Venting options and accessories information page Return to T-KD20 Main Page
	The Takagi T-KD20 water heater is state of the art and uses a sealed combustion direct vent system. No Indoor Air is used for combustion. The T-KD20 should not be used for outside applications - use the Bosch AquaStar 250SX0, Takagi T-K2, TM1 or TKjr for outside applications in mild climates. Model TK-BK01 Wall Hanging Bracket. Mounting of the T-KD20 is accomplished 3 ways. Free standing on a noncombustible base, wall mounting on a noncombustible base, or hung on a wall using the optional Wall Hanging Kit: TK-BK01. Model TK-TV05 Click for picture (front) Click for picture (back) This is the Vent Terminator for the Direct Vent T-KD20 - and is a must for the T-KD20. The TK-TV05 is the only vent terminator approved for the T-KD20 by Takagi. This Vent has a 4-inch hole for the exhaust and a 3-inch hole for the input air. Dimensions of the Vento-Box are: 13 3/4 inches wide by 12 inches tall by 6 3/4 inches deep. Click on text to the left for larger pictures of front and back of the Takagi Vento-Box. Model TK-RE02 Temperature Remote Controller. The output temperature of the T-KD20 can be controlled with a remote controller (up to 150 feet away) with the optional TK-RE02. The controller model TK-RE02 can adjust the output temperature from 100°F (38°C) to 167°F (75°C). Model TK-TV03 A 4-inch back draft preventer should be used when outside temperatures are below 32°F. The TK-TV03 prevents cold air from freezing the heat exchanger on the T-KD20. Z-Flex Venting Z Flex Stainless Steel Venting Accessories with silicone free connections. See our full line of pipe, exterior terminators, elbows and more. Perfect for vertical or horizontal installation. Stainless Steel Venting is required for all Takagi Water Heaters (Exhaust Only). Click here to see sizes and prices for ZFlex Venting Supplies
Return to T-KD20 Main Page