|
Model TK-RE10
|
Temperature Remote Controller. The output temperature of the T-M32 / T-M32 ASME can be controlled
with a TK-RE10 remote controller. It allows output temperatures beyond the factory settings and
shows error codes. The TK-RE10 also monitors incoming and outgoing water temperatures.
The temperature controller can adjust the output temperature from 100°F (38°C)
to 167°F (75°C).
Click here to purchase the TK-RE10
|
|
Model TK-BF01
|
The TK-BF01 Vent Damper prevents the backflow of air through the exhaust vent. This
helps prevent harmful exhaust gases from entering the home, as well as helping to prevent
the unit from freezing in areas where cold air can be blown or drawn into the exhaust
system. Required in weather condtions below 36 F degrees.
Click here for a TK-BF01 venting example
Click here to purchase the TK-BF01
|
|
TM-VC32 Outdoor Vent Cap
|
The TM-VC32 Vent Cap is for outdoor installation of the T-M32 tankless water heater.
The cap is installed on the top of the unit, instead of connecting an exhaust vent pipe.
The cap will prevent any debris that might be in the environment from entering the unit
and causing damage or a fire hazard, as well as preventing rain or other weather
from entering the unit.
Click here to purchase the TM-VC32
|
|
TM-DV32 Direct Vent Conversion Kit
|
The TK-DV32 Direct Venting Kit can be used to convert the T-M32 from a conventional vent
system to a direct vent (or sealed combustion) system. The TM-DV32 Direct Vent kit can be
used to convert the tankless hot water unit from a conventional vent system to a direct vent
(or sealed combustion) system.
Install this conversion kit in accordance with Takagi's
installation instructions and any applicable codes.
Click here to purchase the TM-DV32
|
|
Model TK-TV01
|
The TK-TV01 wall vent terminator for installation of Takagi water heaters to be vented out a
side wall. Connect the Category III stainless steel vent pipe from the top of the unit
to the backside of this terminator to exhaust flue gases through the wall without
a thimble.
Click here to purchase the TK-TV01
|
|
TM-PC32 Pipe Cover
|
The TM-PC32 Pipe cover is designed to be attached directly to the bottom side of
the TM32 Tankless Water Heater to provide a cover for the pipe connection entry.
Click here to purchase the TM-PC32
|
|
TM-MC01 Multi
Unit Controller
|
The TM-MC01 Multi system controller is capable of handling up to 20 Takagi
T-M32 Tankless Water Heaters at one time. It also works as a diagnostic tool that
provides error codes.
Click here to purchase the TM-MC01
|
|
Z-Flex Venting
|
Z Flex Stainless Steel Venting Accessories with silicone free connections. See
our full line of pipe, exterior terminators, elbows and more. Perfect for vertical
or horizontal installation. Stainless Steel Venting is required for all Takagi
Water Heaters (Exhaust Only).
Click here to see sizes and prices for ZFlex Venting Supplies
|
