Tankless Water Heaters / Electric / Gas / Bosch Aquastar / 125FX Vent Kit
  Gas Tankless Water Heaters, Oil Tankless Water Heaters, Propane Tankless Water Heaters, Electric Tankless Water Heaters
  Home
Contact Us
Search - About Us
Shopping Cart
 
HACKER SAFE certified sites prevent over 99.9% of hacker crime.

Gas Tankless Water Heaters
Bosch 2400ES
Bosch 2700ES
Bosch 1600H
Bosch 1600P
Bosch 1600PS
Bosch 1000P

Takagi T-KJr
Takagi T-K3
Takagi T-K3-OS
Takagi T-M32


Rinnai R50Lsi
Rinnai R75Lsi
Rinnai R94Lsi


Electric Tankless Water Heaters
Stiebel Eltron
PowerStar
PowerStream


Electric Mini-Tank Water Heater
Ariston


Oil Tankless Water Heaters
Toyotomi OM-148
Toyotomi OM-180


RV and Boat Water Heaters
RV 500
Boat ShowerMate


Water Heater Venting
4" Z Flex Venting
3" Z Flex Venting
5" Simpson B Vent
6" Simpson B Vent


Water Heater Accessories
Bosch AQ1 Power-vent
Bosch AQ4 Power-vent
Webstones Valves
Water Connections
Whitlam Descaler Solution


PDF Manuals
What Size?
Site Map






Federal Tax Credit for Gas Tankless Water Heaters expires December 31, 2010! Hurry! Save Energy! Save Money!
FXHood Vent Kit for AquaStar 125FX Tankless Water Heater
All in one Exterior Vent and Backflow Preventer for models Bosch 125FX

Return to Bosch Aquastar Tankless Water Heater Main Page

Back flow and Exterior Vent Kit (all in one) for  T-K1, 125FX and 240FX Hot Water Heaters
Bosch FXHood
The FXHood exterior Venting (Terminator) and Back Flow Kit for venting out through a side wall. This is a exterior vent kit and back flow preventer all in one and will prevent cold air from freezing the heat exchanger on the AquaStar Tankless Water Heaters 125FX and 240FX as well as the T-K1 Tankless Water Heater.

Includes a tube of GE high-temperature Silicone Rubber Adhesive Sealant - 10.1 fluid oz. - a $15.00 value.

A back draft preventer should be used wherever the outside temperature can fall below 32 degrees Fahrenheit for all electronic gas tankless waterheaters.

The Bosch FXHOOD is doubled-piped so it can be installed next to combustible material. The face plate is 12 inches by 12 inches and the pipe is 8 inches in diameter with the inner pipe is 4 inches in diameter.
Diagram of FXHood Install

Vent Terminal Clearance


The approved vent terminal must be installed so that flue gases will not jeopardize people, overheat combustible structures or enter into buildings, and so that proper clearances are maintained.

The vent terminal shall not be less than 7 feet above a public walkway.

The vent terminal shall terminate at least 3 feet above any (mechanical) air inlet within 10 feet.
  • The vent terminal shall not be within a 6-foot radius from a gas meter or regulator
  • The vent terminal shall be a minimum of 6 feet from any combustion air inlet
  • The vent terminal shall terminate from an opening window, at least 4 feet below or 4 feet horizontally from the opening
  • The vent terminal shall terminate from a door, at least 1 foot above and 4 feet horizontally from the door
  • The vent terminal shall not be less than 3 feet from an adjacent building
  • The vent terminal shall not be less than 1 foot above grade


Clearances of Terminator for Power-Ventend 125FX, 240FX or Takagi Heaters


Please note: Exterior vent must not be any closer than local code allows - which for most areas is 4 feet from any opening into your home. This means - that a vent can not be closer than 4 feet from windows that can open, doors, forced air inlet, etc. The vent also must be a minimum of 1 foot above grade. If you have any questions on if you can install a tankless waterheater in your house - please click the "contact us" button and give us your information.

Return to Bosch Aquastar Tankless Water Heater Main Page




Thanks for visiting TanklessWaterHeatersDirect.Com